Archive for the ‘Homemade CNC Plasma Cutter’ Category
PLACA PARA CABALLERIZA RANCHO CASIAN
??2mm-F5000-50A-30????
DIY?????CNC??????????Plasma, rezanje krugova
Jedna od prvih proba na mojoj home-made cnc plazmi
http://www.ventpar.co.nr/
http://sites.google.com/site/ventpar/Home
Duration : 0:1:5
cnc plasma taglio
primo taglio con plasma su pantografo cnc fatto in casa
Duration : 0:0:42
Testing homemade cnc plasmacutterzip wire first run
First run with the home made zip wire. Cut from 3mm steel plate with CNC plasma cutter. The pulleys were turned on the little EMCO lathe and even the sticker was home made at home on a Roland CAMM. Just need a platform to launch from and perhaps a longer wire????
Duration : 0:1:10
Another clip of my home made CNC plasma cutter.Dynatorch/1250 Hypertherm
cnc plasma cutting 1/16 sheet, home made water injector to keep smoke and dust down… works good, 1192 pierces on this 4×8 sheet alone, approx 2 hours to cut.
Duration : 0:3:52
Skardenni Homemade CNC-plasmacutter
skardenni plasmacutting with homemade cnc table
Posted in Homemade CNC Plasma Cutter | 
Tags: cnc, control, DIY, emc2, higth, Homebuilt, homemade, plasma, plasmacutting, thc300, torch | 
No Comments »
