Translating...
Torchmate Plasma Tube & Pipe Cutting Attachment
This video shows a 3″ pipe with 120 quarter inch holes cut into it in a uniform pattern around the tube. The system shown uses a Thermal Dynamics True Series Plasma Cutter cutting at 40Amps and 90 inches per minute. We cut the middle part of the video out to save time during download.
Duration : 0:1:14
Posted in 
Tags: 4 Responses to “Torchmate Plasma Tube & Pipe Cutting Attachment”
Leave a Reply
You should have …
You should have seen the guys arm that had to drill all those by hand previously.
Poor piece of …
Poor piece of Steele. All those holes must really hurt.
You are right. We …
You are right. We could have done without it. This was a sample that we did for a customer and decided to film it. We definitely would have saved a couple of seconds per cut by turning off the arc voltage torch height control.
Nice job, but I’m …
Nice job, but I’m wondering why you don’t disable the torch height control to reduce the time of cut. The tube won’t distort that much to need the height control.
Just my two bob’s worth.